Swarf collection
A drawer located at the bottom of the machine allows the collection of swarfs generated during machining, facilitating cleaning operations.
Vice group and out-of-square
Both horizontal and vertical vices are pneumatically operated with a low-pressure device. Out-of-square is managed with the ability to vary the tilt from -45° to +45° with manual handling. The position is read by graduated scale.
Positive indexing stop
The manual 6-position positive indexing stop enables 6 measurements to be set so that the workpiece can be positioned quickly, thus reducing the time of the work cycle. It is also possible to manually adjust the height of the positive indexing stop.
Rapid pneumatic change
Changing the mill assembly is done pneumatically via the control located in the control panel. This allows the mill assembly housed in the machine to be varied and ensuring the machinability of different extrusions.
Tunnel soundproofing
The machinability and support of extrusions even of considerable lengths is guaranteed by the presence of the soundproof tunnel. Placed on the side of the machine, it performs the dual function of supporting the profile and performing the machining paying special attention to acoustic comfort with reduced environmental impact in the workshop.
Control
The push-button panel on the machine control panel allows the management of: air blowing for cleaning the vice table, startup with safety switch, quick tool change.
