LILLIPUT 320 M

Horizontal end milling machine with manual feed. Milling of intermediate angles, +45° / 90° / -45°. High speed of tool rotation for improved quality machining on painted profiles and at intermediate angles. Quick cutter change with pneumatic control. Scratch-proof work table. Fully guarded work zone with high internal visibility

Swarf collection
A drawer located at the bottom of the machine allows the collection of swarfs generated during machining, facilitating cleaning operations.
LILLIPUT 320 M Swarf collection Emmegi
LILLIPUT 320 M Vice group and out-of-square Emmegi
Vice group and out-of-square
Both horizontal and vertical vices are pneumatically operated with a low-pressure device. Out-of-square is managed with the ability to vary the tilt from -45° to +45° with manual handling. The position is read by graduated scale.
Positive indexing stop
The manual 6-position positive indexing stop enables 6 measurements to be set so that the workpiece can be positioned quickly, thus reducing the time of the work cycle. It is also possible to manually adjust the height of the positive indexing stop.
LILLIPUT 320 M Positive indexing stop Emmegi
LILLIPUT 320 M Rapid pneumatic change Emmegi
Rapid pneumatic change
Changing the mill assembly is done pneumatically via the control located in the control panel. This allows the mill assembly housed in the machine to be varied and ensuring the machinability of different extrusions.
Profile support roller conveyor
Enables correct positioning in the machine and secure support of the profile in the machining area. Slide rollers make profile handling operations easier.
LILLIPUT 320 M Profile support roller conveyor Emmegi
LILLIPUT 320 M Control Emmegi
Control
The push-button panel on the machine control panel allows the management of: air blowing for cleaning the vice table, startup with safety switch, quick tool change.

Other Products